question about sleeves now with pictures
#1
question about sleeves now with pictures
i just picked up a complete ls block for $100. he said it was smokign so he tried re ringing it and cracked a ring. but when i tore it open i noticed that the outer part of the sleeve is chipped in a couple of places. the biggest being about 2mm down and a cm acrcoss. so my question is should i run it or no? my camera is being gay so no pics
got some pictures but i suck at resizing so you get thumbnails
got some pictures but i suck at resizing so you get thumbnails
#2
Re: question about sleeves
Originally Posted by tr4cti0n.i55ues
i just picked up a complete ls block for $100. he said it was smokign so he tried re ringing it and cracked a ring. but when i tore it open i noticed that the outer part of the sleeve is chipped in a couple of places. the biggest being about 2mm down and a cm acrcoss. so my question is should i run it or no? my camera is being gay so no pics
#4
Re: question about sleeves
Any gouging in a cylinder is gonna cause some serious compression problems aka none. Basically good block to get sleeved still worht somethin to someone who's goin that route but the typical quick rebuild its junk
#6
Re: question about sleeves
it would cause compression problem if it was cracked on the coolant jacket side? i thought it would be a reliability/strength issue. but i talked to the guy and i might be able to get another block
Thread
Thread Starter
Forum
Replies
Last Post
turboknightmare
General Discussion
9
06-23-2008 07:32 PM
SlowCivicHB
Turbo Parts For Sale
13
07-28-2006 09:43 AM