rudebwoy

you dont really need them. b18a ls motors dont have them, and they work just fine. but the plug kit cost money. last time I checked www.theoldone.com
they had the plug kit

Walter

for any reason they were mounted.. non vtec and vtec engines are diferents.. work differents..so..i would not compare both..i see more obvios if you run with forget pistons ..

Tom-Guy

I've revved stock geometry LS bottom ends to 10K, no squirters needed. They are champs.

lilpooh21186

the only problem im haveing is looking at my block built i dont know how oil will make it up there to lub good

Tom-Guy

Oil flies around inside the engine. That's why they make crank scrapers. Even with a crank scraper you get plenty of lubrication in the bores.

Slo_crx1

Here's a good reason to ditch the squirters...my friend Brian has a 92 gsr, had a stock b17a1 in it with some bolt on goodies but nothing major. He called me up one day saying his rings were shot and he was blowing clouds of smoke out the back, that sucks but whatever...it happens and he has no luck with Honda's. He took the motor out, sent it to a local machine shop for a rebuild. Guy building the motor calls him back and said he found out why his engine was smoking...broken oil squirter pissing on the side of one of the pistons. He said he compression tested the motor before disassembly and it was still in spec. All that trouble for one pos oil squirter. :P

widebody93

I'm not 100% sure but if your forged with iron sleeves you dont need them, but I built my H22A fully and I decided to have a guy custom build a set mocked off mine but have the tubing larger and with a "injector stlye" spray to them. I didnt believe what he was talking about till he had them made and hooked to a pressurized hydraulic system and when they sprayed it was a fine mist that shot about 2 feet. So I put them in but not sure how they act within a pressurized block. No so far no smoking or scarring on the sleeves. I had to pull the head to pull some debree out of the chambers"------- leaves" Thats what I get for running open intake.

lilpooh21186

So i cut them all down and now everytihing fits perfect but the #4 boilt keeps cross threding its in tight but keeps spining but it is hard to move what should i do keep 1-3 and plug 4 or keep it inand hope it doesnt fall out and ---- my life up