oh ----.... over tourqed head studs !!!!!
10-21-2007, 07:42 PM
#3
0.5 BAR
Thread Starter
Join Date: Oct 2007
Posts: 172
Re: oh ----.... over tourqed head studs !!!!!
well after i flipped the ---- out on him i went in and came back out and he lossend the bolts lmfao i guess he thought i wouldnt be as pissed or something
so could i just go buy some new head bolts and head gasket and it be ok or do i need to take the head back in to the shop to see if its worped ?
so could i just go buy some new head bolts and head gasket and it be ok or do i need to take the head back in to the shop to see if its worped ?
10-21-2007, 07:45 PM
#4
0.0 BAR
Join Date: Dec 2002
Posts: 0
Re: oh ----.... over tourqed head studs !!!!!
dude your not warping a head with headbolts
it would require overheating the motor
running uber boost to the point that your temp is has red has hotrex's *** after an ---- gangbang
---- intercoollllerr's dawggggggg
it would require overheating the motor
running uber boost to the point that your temp is has red has hotrex's *** after an ---- gangbang
---- intercoollllerr's dawggggggg
10-21-2007, 09:02 PM
#7
1.5 BAR
Join Date: Feb 2007
Posts: 1,087
Re: oh ----.... over tourqed head studs !!!!!
the car is prolly fine if you didint hear any pops but i guess well find out when the motor heats up expands and your head cracks and ther's a i blew my motor thread wont we!!!!!!!!! over all just run it see what happens
10-21-2007, 09:10 PM
#8
0.5 BAR
Thread Starter
Join Date: Oct 2007
Posts: 172
Re: oh ----.... over tourqed head studs !!!!!
its fare from running !!!! lots of wiring to do and the obd0-obd1 swap so this is why im asking if i should go buy some new head studs and a head gasket what would this have hurt ? or even might of hurt .. i don"t want to ---- this up and have to pull everything back off and do it again
10-21-2007, 09:38 PM
#10
3.0 BAR
Join Date: Dec 2005
Posts: 2,081
Re: oh ----.... over tourqed head studs !!!!!
I dont see why you would need a new head gasket. If it were me I would just re-torque the bolts to spec and call it a day, if you think they are streched at all just get new bolts and be done.
I highly doubt it would hurt anything unless they were torque'd to the point where you stripped threads out of the block. worst case scenario a bolt is streched but I dont know if you can even strech a bolt without running the motor.
Originally Posted by turborex89
what would this have hurt ? or even might of hurt
