Notch for TunerToy Clearance .
 

Does anyone know how much notching is needed on a d16z6 for tunertoy rods , or would i have to take crank, girdle, rods pistons etc, to the machine shop. If theres a certain amount to where i could jus inform my machinest instead of feeding him all these parts, id like to know. Thanx in advance.

Re: Notch for TunerToy Clearance .
 

---- I wanna know too.

Re: Notch for TunerToy Clearance .
 

Die grinder untill they fit :6

Re: Notch for TunerToy Clearance .
 

is there a balance on where the notching is required or , can i set a grind stone to it and just figure from there.

Re: Notch for TunerToy Clearance .
 

Haha a grind stone will fall apart way before you make a dent in a sleeve. You need a carbide burr. They're like $20 at Ace hardware and the things are indestructible. I got a Foley brand I think it was (it came in a red pouch), and with that bitch I did 8 notches in a few minutes.

Re: Notch for TunerToy Clearance .
 

cool thanx. i found a write up on it.

Re: Notch for TunerToy Clearance .
 

post it nigga!

Re: Notch for TunerToy Clearance .
 

Sticky Maybe!
http://www.theoldone.com/articles/d%...ilding%5Ftips/

Re: Notch for TunerToy Clearance .
 

+1

Re: Notch for TunerToy Clearance .
 

if you're gonna bore and hone it, should you notch before or after the machine work? ???

Re: Notch for TunerToy Clearance .
 

machine shop here charges 5 bucks a cylinder for nothing, let them ---- with it

Re: Notch for TunerToy Clearance .
 

Technically hone after notching, but it really doesn't matter if you use a high grit sand paper or emory board to smooth out the the transition. The rings never get down that far, so a hone really wouldn't be important.

Re: Notch for TunerToy Clearance .
 

hey, we should all keep updates with our builds and share info ;D
My build is D16z6
90k original miles owned by an older guy
when i pulled it apart, it looked really mint
.020 over with vitaras

Re: Notch for TunerToy Clearance .
 

I honed befor and then said ---- and did a quick one down the bottem after