HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Hybrid/Tech (https://www.homemadeturbo.com/hybrid-tech-8/)
-   -   new swap, run like shit (https://www.homemadeturbo.com/hybrid-tech-8/new-swap-run-like-shit-67103/)

TimeEater 08-22-2006 09:10 AM

new swap, run like shit
 
I put a ls/vtec in my 92 civic hatch vx. I put 450cc's with a resistor box and wired it up from the write up on h-t. chipped p28 with a new gsr basemap. and tried burning one that i know works on a buddies. The problem is I start it up and the idle jumps up and down at 1500 to 2000, and if i try to step on the gas is bogs and wants to die and then get a code 14 (eacv). I have pulled it cleaned it. I have replaced the TPS and MAP with the ones from my old motor. Cant set the timing with it jumping around but it is running pretty advanced and cannot adjust it back anymore. New plugs and wires. There is black smoke in the exhaust that tells me running rich, but i dont have my O2 hooked up so i cant use my a/f gauge. Any ideas i have been working on this for 2 days and done alot of searching but everything i try isnt working.

JDMFantasy2K 08-22-2006 10:12 AM

Re: new swap, run like shit
 
is the iacv disabled on the chip?

TheMadScientist 08-22-2006 11:49 AM

Re: new swap, run like shit
 
Did you scale the injectors back on the map?

JDMFantasy2K 08-22-2006 04:30 PM

Re: new swap, run like shit
 
are you sure the ecu is good? Block off the IACV and try running it. Also make sure the TPS is good.

TimeEater 08-22-2006 07:01 PM

Re: new swap, run like shit
 
I did scale it for the 450's, and the ecu is the one i used right before i swapped motors. I did change the TPS off the old motor so i know it is good.

TimeEater 08-22-2006 11:30 PM

Re: new swap, run like shit
 
took out the 450's and put the stock ones back in, and took out the resistor box. clipped the j1 jumper and it still runs the same. checked the coolant and it was real low and not circulating. i filled it a little at a time and it did run a litlle better, but still shitty.

JDMFantasy2K 08-23-2006 01:08 AM

Re: new swap, run like shit
 
have you done a compression test?

double check cam timing, inspect for anything weird

And then check your ECT sensor. I believe there's 3 of them. One for the fan, one for the pcm, and a one wire thing that is for the gauge. Make sure both 2 wire ECT sensors are connected, and if i'd test them too. You could also try shorting the ect by connecting the wires in the connector together (with it unplugged from the ect). The will fool the pcm into thinking that the engine is hot and pull fuel. Chances are, if the ect is bad and is stuck open (extremely cold; -44) then it will be dumping in more fuel than it should. As for the iacv code i'd just go over the wiring agan and make sure you don't have a bad iacv.


reactone 08-23-2006 12:04 PM

Re: new swap, run like shit
 
This might be stupid, but are you sure that you have all the sensors hooked up properly? I know that the evap purge sensor and the iacv have identical plugs, I had them backwards on my swap and the idle was all over the place.

JDMFantasy2K 08-23-2006 09:24 PM

Re: new swap, run like shit
 

Originally Posted by reactone
This might be stupid, but are you sure that you have all the sensors hooked up properly? I know that the evap purge sensor and the iacv have identical plugs, I had them backwards on my swap and the idle was all over the place.

haha that must have been great, purging at idle, and iacv engagement at cruise :l

TimeEater 08-23-2006 10:09 PM

Re: new swap, run like shit
 
did a compression test 160 on all four. this is driving me nuts. checked all the sensors and hoses everything looks fine.

Guy-Fast 08-23-2006 10:32 PM

Re: new swap, run like shit
 
cel's

TimeEater 08-23-2006 11:33 PM

Re: new swap, run like shit
 
14 (eacv) that the only code

88dx 08-24-2006 12:53 AM

Re: new swap, run like shit
 
Hold it off the limiter and see if it clears out 8)

TimeEater 08-24-2006 01:42 AM

Re: new swap, run like shit
 

Originally Posted by 88dx
Hold it off the limiter and see if it clears out 8)

i dont know what you mean, as in floor it. not that i would but even if i press the gas it bogs out and tries to die.

iceknight24 08-24-2006 02:00 AM

Re: new swap, run like shit
 
my did the same i had the map and air idol plugs backwords try changing them
also my ls vtec had to be one tooth advance on belt.
if u were in wa i could help better.

Guy-Fast 08-24-2006 04:05 AM

Re: new swap, run like shit
 

Originally Posted by TimeEater
14 (eacv) that the only code

iat and iacv most likely mixed up


also since the car runs so shitty your plugs are most likely fucked


new plugs are in order


then set timing


check to make sure your fpr is getting the right psi

vacuum lines all in proper place



TimeEater 08-25-2006 12:21 AM

Re: new swap, run like shit
 
mother fucker, found it. My hatch is a vx and had has the egr ( exhaust gas recirculation). Part of the egr system is on the manifold and part of it is on the firewall. Since I swapped motors the manifold part was gone and the firewall part was still there and hooked up. I unplugged the connection and reset the ecu and now it runs normal. thanks for the help guys.


All times are GMT -5. The time now is 06:03 AM.


© 2024 MH Sub I, LLC dba Internet Brands