need help anyone have this proplem befored
Thread Starter
1.0 BAR
Joined: Jul 2003
Posts: 271
need help anyone have this proplem befored
need help !
my car is ---- some how after washing the engine bay then i take it out for a ride when i try to step on it .it bogging down it seem like it didn't get enuff air or the timing wasn't right .then today when i stop at the light and put the gear in neutral the rpm goes up to 2 000 rpm and i rev it a lil it goes back down to 700 rpm wtf is wrong anyone know?
my car is ---- some how after washing the engine bay then i take it out for a ride when i try to step on it .it bogging down it seem like it didn't get enuff air or the timing wasn't right .then today when i stop at the light and put the gear in neutral the rpm goes up to 2 000 rpm and i rev it a lil it goes back down to 700 rpm wtf is wrong anyone know?
3.0 BAR
Joined: Feb 2003
Posts: 9,089
Re:need help anyone have this proplem befored
take dist cap off and dry the entire thing inside and out. even the parts under the cap.
Next time bring some plastic bags and cover the dizzy and air filter.
Water+ electronics DOES NOT MIX.
also, cuz shortyz or onyx will say this.. so im gunna beat them to it.
"Post in the right FORUM"
this topic should be in the general forum.
Next time bring some plastic bags and cover the dizzy and air filter.
Water+ electronics DOES NOT MIX.
also, cuz shortyz or onyx will say this.. so im gunna beat them to it.
"Post in the right FORUM"
this topic should be in the general forum.
Administrator
Joined: Dec 2002
Posts: 13,988
Re:wtf is wrong with my car help
jesus, lol 
ok, sounds like you may have some water in the Distributor cap. Go ahead and remove it blow the distributor so its nice and dry, (both sides) and give it a shot again. Also pull the plug wires and make sure there is no water down inside the valve cover/spark plug holes. It could be arching out.
Jeff
ok, sounds like you may have some water in the Distributor cap. Go ahead and remove it blow the distributor so its nice and dry, (both sides) and give it a shot again. Also pull the plug wires and make sure there is no water down inside the valve cover/spark plug holes. It could be arching out.
Jeff
Thread Starter
1.0 BAR
Joined: Jul 2003
Posts: 271
Re:need help anyone have this proplem befored
thank guy hahaha i just did that and now i came to check my post lol i was write about it lolz... man but thank alots peace out any ideal if the splite fire plug are any good?
Thread
Thread Starter
Forum
Replies
Last Post
leed
General Discussion
7
Dec 8, 2005 08:17 AM
ochizon
Engine Management
0
Jun 20, 2005 10:49 PM
