machine shop bill
#1
machine shop bill
I got prices at the local machine shop for work on my engine and I just need opinions on if the price is high or what?
Block work: decked, bore 20 over and hone, clean
Head work: valve job, milled if head is warped any, and cleaned
balance tuner toys rods, wiseco pistons, flywheel, and crank and of course hot tank everything
total: 480..it that expensive??
Block work: decked, bore 20 over and hone, clean
Head work: valve job, milled if head is warped any, and cleaned
balance tuner toys rods, wiseco pistons, flywheel, and crank and of course hot tank everything
total: 480..it that expensive??
#4
Re: machine shop bill
Basic price for that stuff broken down
Deck/Bore/Hone 150 (with deckplate) 80-100 without
Valve Grind 16v 3way Clean and Machine 200-250
Balance bottom end 145 (4 cylinder)
So around 550ish would be normal at a good machine shop.
Deck/Bore/Hone 150 (with deckplate) 80-100 without
Valve Grind 16v 3way Clean and Machine 200-250
Balance bottom end 145 (4 cylinder)
So around 550ish would be normal at a good machine shop.
#8
Re: machine shop bill
Originally Posted by ghettoturbo
balancing gets real expensive
Last head I had valves seated in + milled ran me $178.
$480 sounds about right.