91SiSEZC

Hmm.... with that being said, are there any pistons you would recomend? Do I have to get pistons specific to a ZC engine or can I use pistons from another engine (ie integra)??

HMT-Admin

Call that old ****** up and tell him you want those pistons, he will give them to you. Tell him Jeff @ homemadeturbo.com said So

Yes, you have to use pistons that are specificly for the ZC. If you put a d16a6 piston in a ZC lets say thats rated at 9.1, when you put it in your zc, it would be like 7.8

as far as I know, endyn is the only people who make pistons for the zc. you may want to give J.E/SRP a call and see what they have to offer.

Jeff

HMT-Admin

now that I think about it, if JE has a listing for D16a1 88-89 integra, those will be perfect..

Jeff

yellow90si

to answer on the srp question i think they make them for a d16a6 at 8.8:1 that should be about 9.2 on a zc

HMT-Admin

No, if you put a6 pistons in a ZC, you would get a incredibly low compression ratio...

Jeff

azulito

What about using a SRP D16A6 SRP piston that is rated at 11:1 on the A6? I came up with 9.4:1 on the calculator, (which if you read one of my other posts I am not too sure about).

Does it matter if the piston is dished or domed for turbo? Because of course those 11:1 A6 SRP's are domed.

azulito

After emailing Larry at Endyne here is the latest news concerning ZC FI rollerwave pistons. They will be 75.5mm so you will need to get your block honed. I wasn't planning on doing anything to the block, but now it looks like the way to go for me at least.

"I'm making some higher compression forced induction Roller-Waves. These will be finished in approximately 3 weeks and the CR will be approximately .5 ratio higher than our present pistons for the ZC"

The cr's will be again .5 over what is now available which is 8.23-8.54:1

Now may be a good time to get some if you are looking since this looks like a limited run

91SiSEZC

I called Larry and decided to go with their 8.54:1 pistons, I am going to shave the head .030" and that will boost the compression to 9.15:1.... I figure that going with these pistons instead of a 9.5:1 and losing .4 compression wont be that bad

turbo95

what about a dohc zc with z6 pistons in it?, will the compression be too low?, it should be somewheres around 7.3:1 and what would be safe boost for this?, I was thinking around 15 psi computer is chipped with uberdata with logging adaptor for labtop, factory dohc zc blew at 8 psi , it put a rod threw the block

superd

stock comp. for a z6 is 9.2:1 thats y i drop my z6 to 8.5