Link to H-T for Bearings?
 

I looked for it but could source it:

Does anyone have the link to Honda-Tech for the Colour to thickness measurements of honda OEM bearings. Particularly D-Series bottem ends?

I saw it a while back but now can't find it. I knew I should have book marked it!

Re: Link to H-T for Bearings?
 

Okay found this, but are D and B colours the same thickness?

Main Bearing thickness by color
Blue 2.013-2.010 mm 0.0793”- 0.0791”
Black 2.010-2.007 mm 0.0791”- 0.0790”
Brown 2.007-2.004 mm 0.0790”- 0.0789”
Green 2.004-2.001 mm 0.0789”- 0.0788”
Yellow 2.001-1.998 mm 0.0788”- 0.0787”
Pink 1.998-1.995 mm 0.0787”- 0.0785”
Red 1.995-1.992 mm 0.0785”- 0.0783”

Rod bearing thickness by color
Blue 1.510-1.507 mm 0.0594”- 0.0593”
Black 1.507-1.504 mm 0.0593”- 0.0592”
Brown 1.504-1.501 mm 0.0592”- 0.0591”
Green 1.501-1.498 mm 0.0591”- 0.0590”
Yellow 1.498-1.495 mm 0.0590”- 0.0589”
Pink 1.495-1.492 mm 0.0589”- 0.0587”
Red 1.492-1.489 mm 0.0587”- 0.0586”

Re: Link to H-T for Bearings?
 

i would assume so. im going to honda sometime this week for some bearings. probably just going to buy 2 brown bearings because their cheap just to spec out which ones i need. the greens are like 12 bucks a piece :-X maybe i should just ask one of those guys there. i doubt they'd know though ???

Re: Link to H-T for Bearings?
 

There are markings on your block and crank that tell you what size you need. If the crank has been polished, yeah, it gets a little off sometimes. Otherwise, you are good to go.

Why not run a $50 set of ACLs and be done with it?

Re: Link to H-T for Bearings?
 

Do the ACL bearings have all the diffrent thicknesses that the honda bearings do? I am building a gsr that the crank just was turned .10 and it had green honda bearings in it before. I am going to run ACL's. So do i just get .10 over bearings?


steve

Re: Link to H-T for Bearings?
 

yup.

Re: Link to H-T for Bearings?
 

Oh I know that, Bearings have been ordered OEM Hondas, but I just want to spec everything out right.