just swapped dash and cluster???
#11
Re: just swapped dash and cluster???
Originally Posted by moto21dx
lol not really. air bag does more damage to you than my cage and harnesses will do.
#12
Re: just swapped dash and cluster???
well since the harnesses are properly attached to a harness bar, which is part of the cae, there wont be any bars getting close to my face. thanks anyways though....
but when your nipples get burned off by the airbags, ill laugh at you.
but when your nipples get burned off by the airbags, ill laugh at you.
#13
Re: just swapped dash and cluster???
Originally Posted by moto21dx
well since the harnesses are properly attached to a harness bar, which is part of the cae, there wont be any bars getting close to my face. thanks anyways though....
but when your nipples get burned off by the airbags, ill laugh at you.
but when your nipples get burned off by the airbags, ill laugh at you.
#14
Re: just swapped dash and cluster???
ok, so then you make no sense lol. jocking on me using harnesses and a cage... yet your having the same thing
anyways. back to my fucked *** idle. where should I begin with this check?
anyways. back to my fucked *** idle. where should I begin with this check?
#15
Re: just swapped dash and cluster???
Originally Posted by moto21dx
well since the harnesses are properly attached to a harness bar, which is part of the cae, there wont be any bars getting close to my face. thanks anyways though....
but when your nipples get burned off by the airbags, ill laugh at you.
but when your nipples get burned off by the airbags, ill laugh at you.
On-topic: You fucked something up. I swapped my dash out a while back, there is nothing that you should be touching that would affect the rev limiter. Were you having any of these problems b4 you did the swap?
#16
Re: just swapped dash and cluster???
again. im 6'5" im as far from my wheel as possible just to drive, and my harnesses dont let me move, so thasats not an issue.
Im not sure about how my idle was before. I didnt have a tach before. so that part is unknown. I know my shift points are all the same. and the egine sounds the same. So im assuming ive been reving like this the entire time after i swapped the zc. Im not sayin that my dash swap caused this. im saying how do i fix it? its been this way it seems for over a year now.
Im not sure about how my idle was before. I didnt have a tach before. so that part is unknown. I know my shift points are all the same. and the egine sounds the same. So im assuming ive been reving like this the entire time after i swapped the zc. Im not sayin that my dash swap caused this. im saying how do i fix it? its been this way it seems for over a year now.
#17
Re: just swapped dash and cluster???
Originally Posted by moto21dx
again. im 6'5" im as far from my wheel as possible just to drive, and my harnesses dont let me move, so thasats not an issue.
Im not sure about how my idle was before. I didnt have a tach before. so that part is unknown. I know my shift points are all the same. and the egine sounds the same. So im assuming ive been reving like this the entire time after i swapped the zc. Im not sayin that my dash swap caused this. im saying how do i fix it? its been this way it seems for over a year now.
Im not sure about how my idle was before. I didnt have a tach before. so that part is unknown. I know my shift points are all the same. and the egine sounds the same. So im assuming ive been reving like this the entire time after i swapped the zc. Im not sayin that my dash swap caused this. im saying how do i fix it? its been this way it seems for over a year now.
#18
Re: just swapped dash and cluster???
im about to just drop this bitch off at the shop and say take care of it. sinec i now have a few thigns that needs direct attention. im tired of ------- with it at this point.
a/c needs to get fixed (and yes i NEED a/c) too hot here.
idle loop is ------- annoying, and ive checked everything.
rev limit is likely the stock ecu not being compatible fully with the zc. so its getting uberdata. maybe also my looping issue?
and getting a lower ball joint replaced.
a/c needs to get fixed (and yes i NEED a/c) too hot here.
idle loop is ------- annoying, and ive checked everything.
rev limit is likely the stock ecu not being compatible fully with the zc. so its getting uberdata. maybe also my looping issue?
and getting a lower ball joint replaced.
#19
Re: just swapped dash and cluster???
quit bein a loser n put everything back haha... ur the one that fucked it up cuz u wanted a black dash? why did u swap harnesses and ----? "unplug air bag, remove bulb... done" why didnt you just do that? harness may be different? figure it out. why have a shop fix issues you caused. lazy ----
#20
Re: just swapped dash and cluster???
um ok moron..., the air bags are gone. the harness for srs is GONE, the BRAIN IS GONE... im not caring about the bulb anymore, its taken care of.
i swapped harnesses because the ddash i had didnt have one. so its all my same ----, minus airbags, with a diferent wheel and vx cluster. everything was done to the book.
my idle didnt start AFTER this. its done it for a year almost now. but only now can i see that it loops from 1200 rpm ----- > 1700 rpm. i didnt have a tach before. sorry im not all performance cheapo bs like the most of you guys. i like it all.
So unless you have useful info, just gtfo, and call it a day.
i swapped harnesses because the ddash i had didnt have one. so its all my same ----, minus airbags, with a diferent wheel and vx cluster. everything was done to the book.
my idle didnt start AFTER this. its done it for a year almost now. but only now can i see that it loops from 1200 rpm ----- > 1700 rpm. i didnt have a tach before. sorry im not all performance cheapo bs like the most of you guys. i like it all.
So unless you have useful info, just gtfo, and call it a day.