Jeff, what axles did you use on your CRVTEC?
 

I thought that I read somewhere that you used a like 94+ int. shaft and axles... Im using 90-93 teg axles and int. shaft and I get severe axle buckle.... Any insight on your setup would be greatly apprciated..

thanks

Blaze

Re:Jeff, what axles did you use on your CRVTEC?
 

it all depends on what tranny u have..

but u say you have 90-93 int shaft and axles on there now?

Re:Jeff, what axles did you use on your CRVTEC?
 

I have a 91 Teg tranny and the 90-93 teg LS axles and intermeadiate shaft. Aby more insight would be rad.

Blaze

Re:Jeff, what axles did you use on your CRVTEC?
 

did u remove the spacer on the hub???

read here.. great info on bseries swaps into EFs.
http://www.hasport.com/News/Articles...rt%20Axles.htm

i am assuming this swap is going into a 4g civic/crx right?

Re:Jeff, what axles did you use on your CRVTEC?
 

Jeff uses 'GSR' axles...

Re:Jeff, what axles did you use on your CRVTEC?
 

Yeah the swap was into a 91 CRX. I have read the web site over and over and even called hasport. If Jeff is running GSR axles, what int shaft is he running? They didnt make a GSR from 90-93 did they....

Re:Jeff, what axles did you use on your CRVTEC?
 

dude tehy made a 92-93 GSR 1.7 DOHC VTEC for the tegs.

Re:Jeff, what axles did you use on your CRVTEC?
 

they made a GSR 92-till the end, they will all work with the right axles

Re:Jeff, what axles did you use on your CRVTEC?
 

its very simple, use whatever axles for whatever intermediate shaft you are running, and remove the dust seals on the hub.

end of story,

unless your running a JDM intermediate shaft which requires custom/hybrid axles or a set from raxles. all this info is at www.hasport.com

I run 94 gsr axles with a 94 gsr intermediate shaft.

Re:Jeff, what axles did you use on your CRVTEC?
 

I'm running a JDM B16 with a JDM YS1-"LSD" trans and I used 90'-93' teg axles and and just removed what the articles told me to do. I have had no problems but the outter joints make alittle noise every once in awhile but thats just cause my car it lowered a good deal cause I had the same problem with the outer joints making noise with my old ZC. I won't raise the b**** till I buy axles worth doing i.e. stage #2 axles or something. until then hello warranty.

P.S. Do the axles work fine and run fine just alittle buck.