i need some help...:)
#1
i need some help...:)
ok...my setup is as follows. t3 tubro custom setup blah blah...my managment is dsm 390s with a turboedit map...my car idles great but when i hit the gas it bogs down real hard and then revs to 3k and basically hits a limiter. its through 2 codes. 4 and 7...4 is the crank angle sensor and 7 is the tps. i also did the mpfi swap so thats where i thought i went wrong. i double checked my wires and the c1 is going to blue green and c2 is going to blue yellow just like its suppose to. and i swapped the wires on the tps like it was said to. i really have no clue whats going on.
***note, when i started the swap, i didnt have the si ecu or distirubtor. my friend tried starting the car without the Crankle angle sensor wires hooked up. it didnt start, but would that have messed anything up?.
any clues as to what might be wrong. i have checked and double checked my wiring. seems to be just the way its suppose to.
any help is great
***note, when i started the swap, i didnt have the si ecu or distirubtor. my friend tried starting the car without the Crankle angle sensor wires hooked up. it didnt start, but would that have messed anything up?.
any clues as to what might be wrong. i have checked and double checked my wiring. seems to be just the way its suppose to.
any help is great
#2
Re:i need some help...:)
4- Accord Civic CRV CRX Del Sol Odyssey Prelude
90-98 88-98 97-98 88-91 93-97 95-98 85-98
CKP Sensor (Crankshaft Position Sensor)
defective circuit or unplugged / defective sensor
7- Accord Civic CRV CRX Del Sol Odyssey Prelude
85-98 86-98 97-98 85-91 93-97 95-98 85-98
TP Sensor (Throttle Position)
defective circuit or unplugged / defective sensor
could the sensors and or plugs be bad? another note...when i put the stock ecu back in it only threw the Crank angle sensor code...wierd
90-98 88-98 97-98 88-91 93-97 95-98 85-98
CKP Sensor (Crankshaft Position Sensor)
defective circuit or unplugged / defective sensor
7- Accord Civic CRV CRX Del Sol Odyssey Prelude
85-98 86-98 97-98 85-91 93-97 95-98 85-98
TP Sensor (Throttle Position)
defective circuit or unplugged / defective sensor
could the sensors and or plugs be bad? another note...when i put the stock ecu back in it only threw the Crank angle sensor code...wierd
#4
Re:i need some help...:)
Originally Posted by crx88Si
i'd try two things
1. switch the wires on the tps again.
2. are there two white wires on the dist, sometimes those need swapping and it'll work.
1. switch the wires on the tps again.
2. are there two white wires on the dist, sometimes those need swapping and it'll work.
#7
Re:i need some help...:)
ok that didnt work man...when i swapped the two white wires it wouldnt start. and when i put them back it did...it didnt make any difference when i swapped the TPS wires so im thinking that sensor might be defective. any suggestions??