bikerchris13

Thanks, I pulled the plugs while on lunch break and it looks like only one cylinder got water in it. I'll try that, can't hurt at this point.

MikeJ-2009

I have a D15b2 and a D16a6. The A6 is missing two valves and a cam. The D15b2 is a complete longblock with a headgasket problem arrising. Both blocks should be fine to get you up and going. (*As honestly as I can tell you) My friends coming to pick one up tonight, (not sure which one) but you can have the one he doesn't decide to pick up. Pay shipping and it's yours.

* I didn't pull these motors, but I feel confident that either one will get you going. Bognak or 88Turbocrx can tell you more, as they are the ones that pulled these motors. But since I picked them up for free, they didn't have any reason to lie to me to make the sale, and this is what they told me. Good luck.

bikerchris13

Thanks stealthmode. I blew the water out of the motor which was just in cylinder 1. I got it to start but there is a rod rattling around pretty good. Let me know which block is left behind and about what it would cost to ship to 72076. Thanks again.

MikeJ-2009

Ok, I figure it out in the next day or so and let you know. If you get impatient or you needed it sooner, just pm me and tell me to hurry the ---- up.

Honda16hb

that really sucks for you man, when the water got in your rod bent, but at least it runs for you. I had a bitch of a time with my b16a after I overheated it, so I know what it's like to have a fucked up car.

Bobohc3d

my friends rods were bend after that...
i guess youll have to rebuilds some part of the engine