Anyone have some sites how to install and adjust camber kits, and also maybe aftermarket springs?

Oh guys, if u remeber, I went with the H&R race springs and Skunk2 camber kit

 

springs are easy, just take apart your stock suspension (make sure and use a spring compressor) and put it back to gether the same way you took em off. the camber kit, basically, adjust it, and then drive the car, stop, look if it looks good you're done, if it doesn't do it again.

 

well a rear camber kit is as easy as installin gr8 or gr9 washers on the upper control arms body mount...

 

Try to use a good spring compresser not the ones like from auto zone that have two compressors that clamp to each side of the spring . Its doable but they tend to slide to the sidetill they are like next to another. Dont know how to explain it But for not having to pay for it why not right.

 

yeah, you can just use a regular manual for your car and just install the springs the way that it says to remove/install new factory springs. as for the camber kit, install it the way it would say to remove/install your upper control arm or "a" arm (i think it's called an upper control arm), and yeah, for the rear camber, just use washers.

 

Not to be mister nit picky..but if you want to do things the "right way"..you should eyeball things up when you get it all put back together and go and get an alignment. It just matters how long you want your tires to last (if you don't care about that than dono't worry about it)