how do u use the clutch alignment tool?
#11
Re:how do u use the clutch alignment tool?
BTW when i tried to put the PP in there is a big gap in between the PP and the flywheel....
am i just suppose to tighten it until it flush?...and is that 19 lb going to do it?...
am i just suppose to tighten it until it flush?...and is that 19 lb going to do it?...
#12
Re:how do u use the clutch alignment tool?
make sure you have the spring part that sticks out tword the pressure plate. if it stickout a little the bolts will tighten that all down. go till there hand tight, no really tight but just really really snug.
#13
Re:how do u use the clutch alignment tool?
Yep...19 Ft. lbs. is perfect. The fingers will slowly pull down as you tighten the PP down. They should be almost flat when you have it to the Flywheel. Tighten the PP bolts in a star pattern like lug nuts. You want the clamp to be even. Also make sure the PP and the F/W are VERY clean. If there is ANY contamination on them, you run the risk of chatter.
Thread
Thread Starter
Forum
Replies
Last Post
pac_crx
Hybrid/Tech
8
04-17-2007 11:27 PM