how big of an overbore could i go without sleeving the block???
this will be "semi-built" for boost im tryin not to sleeve my block...it's a dohc zc so i need to know how big of an overbore could i go without sleeving the block???
|
Re: how big of an overbore could i go without sleeving the block???
Originally Posted by 2stockrocketz
this will be "semi-built" for boost im tryin not to sleeve my block...it's a dohc zc so i need to know how big of an overbore could i go without sleeving the block???
|
Re: how big of an overbore could i go without sleeving the block???
everybody says no more than .40 so i went .20 to be super safe
|
Re: how big of an overbore could i go without sleeving the block???
on tock sleeves with no support i would not overbore the engine.
|
Re: how big of an overbore could i go without sleeving the block???
20 is as much as I would bore over stock sleeves.
|
Re: how big of an overbore could i go without sleeving the block???
.20 over and post that bitch :y
|
Re: how big of an overbore could i go without sleeving the block???
Originally Posted by B18TurboEF
Honestly it would be a negative to bore the motor, you would gain minimal hp while increasing the risk of cracking a sleeve substantially, if you HAVE to bore it, go as little as possible ;)
Originally Posted by 91efate
.20 over and post that bitch :y
|
Re: how big of an overbore could i go without sleeving the block???
76mm (.040") works fine for NA, dunno about boost though.......
|
Re: how big of an overbore could i go without sleeving the block???
Originally Posted by Mista Bone
76mm (.040") works fine for NA, dunno about boost though.......
|
Re: how big of an overbore could i go without sleeving the block???
I went 76mm. It was fine untill I tried to tune it myself. :1
|
All times are GMT -5. The time now is 09:58 AM. |
© 2024 MH Sub I, LLC dba Internet Brands