stro83

How strong are the honda crankshafts for the D16 seris motors. I am going to turbo my honda using a T3 nissan 300zx turbo. And I plan on running about 8.5:1 comp. How much PSI can the D16 take if my motor has extra mods as well. pistons,rods,head ported polished,valves,springs,cam,lightened flywheel,stage 3 clutch,titanium head studs,and adjustable fuel regulator. Any help is welcome.

whiterice

as long as you have that, you're set. hehe.
the crank should take anything you throw at it. the rods and sleeves would go before that. the key is to get the bottom end balanced. crank, pistons, rods.

stro83

alright thanks for the info I plan on lowering my comp down so I can run more boost for the motor and I will probably put a intercooler nos/co2 kit on it.

Ravage70

your wastin 2 much money on ur d if u dont sleeve it...then again why sleeve a d when u can make a killer b

Ravage70

well i really hope ur right
its actually really hard to even get to 300whp with a stock head

maybe his setup will make it easier