help zc craps out at 2,500 rpms
just got my zc running in my 91 civic dx...it runs fine and idles fine..but it'll crap out at like 2,500 rpms..when you rev on it or drive it..
anybody have an idea what it is?...could it be my wiring for the multi point conversion?..help me out..thanks |
Re:help zc craps out at 2,500 rpms
What ecu are you uing? Any check engine lights? Re-trace your MPFI wiring abd make sure the conections are tight and in the right spots.
|
Re:help zc craps out at 2,500 rpms
yeah if u got check lights. figure that out first. thats what mine did when we first did the swap a few years ago. it just boggs like crazy and doesnt go past 3k. and then one day my friend fixed it for me. toyed with the harness. i dont know that fool ghetto rigged it. so i just went out and bought the whole crx si harness for my car and everything was cherry. but if your gonna do that for your car get it out of 90-91 civic si cause 88-89 has different type's of plugs i believe
|
Re:help zc craps out at 2,500 rpms
did you swap the wires on the tps? cuz u have to due to the DPFI TPS going the opposite way ;)
also I hear that there are two white wires on the dist that might be backwards. |
Re:help zc craps out at 2,500 rpms
yea..i've swapped the wires on the tps..but i haven't swapped the wires on the dist yet....i didn't do that...because most mpfi conversion websites don't include that..but i mite try it...i'm running the zc ecu..
|
Re:help zc craps out at 2,500 rpms
but you don't have any cel's??
|
Re:help zc craps out at 2,500 rpms
did you change the timing belt? if so, check your timing
|
Re:help zc craps out at 2,500 rpms
yeah do u have any check engine lights???? if so what are they...maybe its the crank angle sensor. i think thats what was fucked on mine.
|
Re:help zc craps out at 2,500 rpms
;D ;D
yes,code #4,CKP,crank position sensor. thats what mine was.Its a grey plastic wheel in the distributor.I spent about 4 hours swapping it out with one from a d15 dis. still didnt work. I just replaced dizzy |
Re:help zc craps out at 2,500 rpms
i just put a brand new zc dist in...but haven't switched the wires on the dizzy yet...i've only heard of a few peep's swapping the wires on the dizzy...so not sure if
i should do it yet...i'll check the cel codes... |
All times are GMT -5. The time now is 11:30 PM. |
© 2024 MH Sub I, LLC dba Internet Brands