Head Stud Question
#1
Head Stud Question
I'm putting together my wish list and I've come across a question. I'm going to be putting down at least 250hp on my d16z6, I was wondering would stock head studs be sufficient? Or would I need some good ARP studs? Elaborate
If so does one of HMT sponsors sell them?
If so does one of HMT sponsors sell them?
#4
Re: Head Stud Question
Originally Posted by ratcityrex
I would def. recomend the head studs. since is a D. I poped 2 HG, picked up the arps from tuner toys and havent had a problem since then. Same tune too.
#6
Re: Head Stud Question
I went to their website. http://www.alamomotorsports.com/arp/hshonda.html
I'm looking at these
208-4301 Honda D16A & D16Z M10 12pt head stud kit w/Std-Cut Studs
Is this the correct one I need? Again, its for a D16Z6
I'm looking at these
208-4301 Honda D16A & D16Z M10 12pt head stud kit w/Std-Cut Studs
Is this the correct one I need? Again, its for a D16Z6
#8
Re: Head Stud Question
Originally Posted by ifly87
what do you torque them to? and how much boost are you running? supported sleeves? I keep popping them
Im running stock a6 block/head with the felpro mls hg from a z6. 12-13 lbs from a T04 40trim. and I torque them to I think 85 lbs. I always torque the d's 10lbs more than what you are supose too.