H22 dyno sheet
This is my 90 Accord 2 door with a JDM h22a bone stock except a cheap ebay ram air intake
http://pic16.picturetrail.com/VOL695...1/69048860.jpg I am in the process of putting it back together: Darton sleved 9:1 Je pistons Eagle rods Arp studed All new bearings and seals crank polished/balanced ACT stage 3 clutch kit t3/t4 turbonetics kit Tuning with vafc II for now till I get Hondata Ill be bringing it down to Waynes again in a few weeks to have it tuned and ill post the new sheet.. Any wagers on the possibility of doubling the first dyno run? |
Re:H22 dyno sheet
it should be about 250-260 @10 psi with good tuning on the AFC
|
Re:H22 dyno sheet
I hoping for more.. but if i dont hit my 350hp mark i will do some head work. if thats still not enough i will spray it.
|
Re:H22 dyno sheet
165 HP?? I thought they were a good 200ish.. anywho, nice avatar but make it smaller :P And good luck with the turbo H22!
|
Re:H22 dyno sheet
200 is flywheel. #'s are right on for a stock h22
|
Re:H22 dyno sheet
Ah, thanks for clarifying Chris :D
|
Re:H22 dyno sheet
Depends on the turbo you're using...compressor size etc...
With an afc you can't fine tune it. |
Re:H22 dyno sheet
t3/t4 is all i know about the turbo its a turbonetics kit no numbers on it to look up the trims.
|
Re:H22 dyno sheet
i doubt you'll hit 350 with 10 psi and the afc hack :-\ i believe jeff only squeezed out 340 ish on 12 psi with some damn good tuning and a bigger turbo ;)
|
Re:H22 dyno sheet
i am thinking 10 psi on the street only at the track ill go up to 15 is my 450's will hold it.
|
All times are GMT -5. The time now is 01:52 PM. |
© 2024 MH Sub I, LLC dba Internet Brands