further info for diy obd0-obd1 harness
 

was checking through the already posted thread ad need a little more clarification.. i read the pgmfi write up on it and am still a little confused.. any help is greatly appreciated

Re: further info for diy obd0-obd1 harness
 

i have read the post, made many harnesses off it... no problems....


your post just states your confusion, and does nothing to help us help you... read your post again, then read the OBD0 to OBD1 post again... then if you still have questions, ask them...

Re: further info for diy obd0-obd1 harness
 

Their only $100 just be lazy and buy one :6

Re: further info for diy obd0-obd1 harness
 

ok i went back through it and now i get it.. i was confused about kurts write up but now that i look a little harder i see what he did.. now my only other question is i know he did it for a z6 but is that going to effect the fact that im going to be using a po6??

Re: further info for diy obd0-obd1 harness
 

well i have the pm6 plugs lying around,and the obd1 plugs with some wire can be had cheap.. so add it up

1.pm6 ecu female plugs...cost $0
2.92-95 civic ecu male plugs w 8" wire...cost $14.99
3.you own 0bd0-obd1 conversion harness....total $14.99
savings of $95 dollars

doing it yourself and gaining more management knowledge....$priceless

Re: further info for diy obd0-obd1 harness
 

$100 - $15 = $85

knowing elementary mathematics...$priceless$

O0

Re: further info for diy obd0-obd1 harness
 

P05 = P06 = P07 = P09 = P28 = P30 = P61 = P72 = P75..... you get the idea.. they are all wired the same, its just that some have VTEC, VTEC pressure switch, knock sensors, different O2 sensors...etc just wire it up for the P28 like he shows. i highly doubt that you will use the knock sensor on a P30/P61/P72 if you even have one (i have one, and dont use the KS) so dont bother wiring that. and you can turn off the O2 senor, and heater so you dont need those extra 3 wires either.


http://home.comcast.net/~turbohf/ecu01.JPG

that harness there will run a P30/P61 in a EF. with no external harness like the instructions have. the only thing it wont support is a 4 wire O2 sensor (i dont run O2 sensors)...

Re: further info for diy obd0-obd1 harness
 

before you shoot your mouth off you better go to chris's site and see what he sells them for..107 plus shipping so 107-15 is $92 plus at least $3-5 bux for shipping what does that calculate to be there genius???? $95 at least... now you do the math :1

Re: further info for diy obd0-obd1 harness
 

perfect i just bought my obd1 dist. and my civic harness plugs are on the way.. now all i need is a po6 to get rolling with crome

Re: further info for diy obd0-obd1 harness
 

i have a chipped P28 ready to roll.... $140shipped :-*