buk9tp

ok so

gsr crx

only code i have now is code 10.. ill change the sensor later..

car in neutural rev it as high as you want.. engine is healthy no issues at all..

get in the car put it into gear and drive..

if you drive slowly it drives fine.. stay under 3k rpm and the car drives fine!

the second you go over 3k it falls flat on its face! like no fuel!

so i can get in the car and drive it all day if i stay under 3k rpm but the second i get on it the car falls FLAT and stays there no matter how long you hold down the throttle..

hondacivc93

is running shitty like its missing or like flat on its face like fuel cut?

buk9tp

its not like a rev limit...

its like 99% flat and the other 1% is a pop you hear every couple seconds

but under 3k rpm the car runs and drives fine

rosario4124

Quit being a lazy niggaarrr and change the damn sensor jay(AIT sensor i think) , and is ur tps set correctly?

buk9tp

im not getting a tps cel..

i had a friend unplug his iat sensor and it didnt even make a different on his car why would it make a difference on mine

rosario4124

a wire on my AIT was fucked up once and it wouldnt even start all it would do is crank and crank and crank. well replace it and see whats up. :P

hondacivc93

i would think that if it runs fine below 3k then IAT wouldnt affect it much above that.

stenseltizm

aren't you using some rtp board or something? Make sure you don't have any full throttle shifts or launch or anything set.

Guy-Fast

clean iat sensor and plug


bust out multimeter



did you get new plugs for this motor?

Bone1

limp mode like your puny sand dick.