Fucking stock Head gasket!! need help
does any one have any tricks to getting the rest of the stock composite ---- from the head gasket and head?? i've tried razor blades.. carb cleaner... kerosine..and the ---- just won't come off and i'm not going to get anything milled to clean it up..
|
Re:Fucking stock Head gasket!! need help
use a small paint scrapper with a wide flat blade, dont us a screwdriver.
|
Re:Fucking stock Head gasket!! need help
i tried that too.. and a wide ass razor blad..the ---- is crazy stuck on
|
Re:Fucking stock Head gasket!! need help
man up nucca...that ---- takes time to do it without ------- up the block or head sometimes. Ive seen people do it with a little wheel on an angle grinder but i was always afraid to
|
Re:Fucking stock Head gasket!! need help
Yeah, wouldnt do the angle grinder method on an aluminum block, get a gasket scraping tool and go to town dude.
|
Re:Fucking stock Head gasket!! need help
Originally Posted by nonvtec
Yeah, wouldnt do the angle grinder method on an aluminum block, get a gasket scraping tool and go to town dude.
|
Re:Fucking stock Head gasket!! need help
They have these circle pieces that are gasket removers. They dont take metal away and can be found at any harbor freight or tools store. Razor is only good for large chunks you gouche into it enjoy a blown hg
|
Re:Fucking stock Head gasket!! need help
i'll have to see if i can find some kind of gasket remover you guys are talking about... thanks for the advice
|
Re:Fucking stock Head gasket!! need help
You need red 3m circle pads. You can buy a set at Vatozone.
|
Re:Fucking stock Head gasket!! need help
Originally Posted by CSaddict
You need red 3m circle pads. You can buy a set at Vatozone.
|
All times are GMT -5. The time now is 11:45 AM. |
© 2024 MH Sub I, LLC dba Internet Brands