bipedbear

im finishing up fixing my turbo kit again, and put in my dsm injectors.....im using resistors, not a box, do i just cut that plug off that the injector wires go into, and install resistors to the wires instead of the plug

AgentMurdoc

You pull apart the harness, look for the yellow wire with a black stripe, each injector has one.

Basically cut the wire, insert the resistor in between, twist the ends, solder it, and then wrap it up with some electrical tape.

Repeat for injector 2, than 3, than 4.

SpankedYA!

Yeah what he said but use heat shrink tubing and wire loom.

AgentMurdoc

shrink wrap is for wussies :P I was gonna mention that, but electric tape is cheaper, cause he's probably already got a roll :P

SkunT

i like heated electrical tape myself. it works nice. just enough so it seals everything all tight.

whiterice

you could actually do 3, then, 4, then 2
or 4, then 2, then 3
well, i guess the order doesn't matter. ya. um. i'm just adding 0 help here.
good luck! don't burn yourself. safety first!

Cray91

Wrong forum. Can't beleive that it slipped by

one agentMurdoc

whoa you're one of the hardcore injector installers. But for your method to work, don't you have to do a backflip in between after you finish the 4th injector before you do the 2nd? You have to make sure you fill the guy in with all the little details, they are extremely important, it's a matter of a good back or a broken back

SkunT

------ newbies. :P

one agentMurdoc

dammit man you're hurting my feelings


I ight have to school you on being a post ----- and get my 2497 posts back in a matter of days