distributor
#3
Re: distributor
really there isn't too much to messup. I just the internals of a b7 dist into a y7 and voila! a OBD2 dist that's now setup for a obd1 harness and looks stock without any cutting. There's only 9 bolts you have to remove. Don't disconnect any wires and just completely swap everything right over. Bolts right up no problems. This would be nice those swapping in z6's into EF's and not having to deal with the modding the a6 dist to the z6 head. Don't worry I was never one for messing around with dist's but once you take it apart there really isn't much there at all to messup. The sensors on the bottom can only go one way since the wires are long enough to one to set higher then the other.
Thread
Thread Starter
Forum
Replies
Last Post