distributer
#1
distributer
is the only differnce between all the different odb dissy(obd 0, obd 1, obd 2) just the plugs and how they mount? the wires are the same, so if i just change the plugs, would it work ok? im putting a obd2 dissy on a d16z6, but im running it non obd. i just wanted to check before i go cutting plugs off.
#2
Re:distributer
now it wont work.. the sensores are diff somewhow not sure how but it wont work ive tried.. u need to use a 90 si and it wont mount right but u can get 1 bolt in and the other on the side of the right one.. and nothin on the top..
#3
Re:distributer
In short, No.
OBD0 and OBD1 have different CYP sensor tooth counts.
Im not aware of OBD1-2 differences.
Match your ECU to the distributor (OBD-wise)
If you put a OBBD1 ECU togther with an OBD1 distributor on a Non-OBD harness(for example), then you can just splice the wires to make the connectors works.
OBD0 and OBD1 have different CYP sensor tooth counts.
Im not aware of OBD1-2 differences.
Match your ECU to the distributor (OBD-wise)
the wires are the same, so if i just change the plugs, would it work ok?
Thread
Thread Starter
Forum
Replies
Last Post