d16z6 TT rods in a d15b block?
I have some TT rods and vitara pistons. Would these fit in my d15b? I've read on another forum about this, but I figured the d15b block is too short, then again i donno.
Nick |
Re: d16z6 TT rods in a d15b block?
the pistons will stick up .018-.020", ok if your running a open chamber head like Z6 or A6
|
Re: d16z6 TT rods in a d15b block?
Mista,
Isnt the d15b head the same cast as the z6 head? So that puts me on the safe side. I tried using a calculator to check the static compression, without luck. Do have any idea what kinda compression that would make? Thanks Nick |
Re: d16z6 TT rods in a d15b block?
Here is my calculation which could be wrong
d15 has a 75.00 x 84.5 bore/stroke ccv 34.60cc Piston Dome Displacement for vitaras = -12cc and the compression ratio comes out to 8.35:1 Does this sound right? |
Re: d16z6 TT rods in a d15b block?
No it is going to be a little higher than 9:1. |
Re: d16z6 TT rods in a d15b block?
2 Attachment(s)
Originally Posted by MADMAX
No it is going to be a little higher than 9:1.
If stock is 9.2:1 and your adding a dish, definitly gonna drop a good amount......... oh snap......I even got pics :) Attachment 31916 Attachment 31917 |
Re: d16z6 TT rods in a d15b block?
Originally Posted by Mista Bone
nope, below 9:1
If stock is 9.2:1 and your adding a dish, definitly gonna drop a good amount......... Ya if the D15B was 9.2:1 in stock form. It is actually closer to 9.6:1. The P08 pistons have less of a dish than P28s. Vitaras have a higher comp height too, so some of that extra dish is being taken away. I run LS/Vitaras in my D15B. |
Re: d16z6 TT rods in a d15b block?
sounds like my build.
|
All times are GMT -5. The time now is 07:56 PM. |
© 2024 MH Sub I, LLC dba Internet Brands