ProzacOverdose

car started...no chck engine light, no nothing. So....I had to pull the dam dash off because the idiot painted and staple everything. So.....the only thing I removed was teh pass airbag. The old original dash had the airbag...the new one I was putting in didin't. No biggie...I took the metal bar out...and CUT the wires to the 2nd air bag. I put everything back in....Correctly with all clips put back in the same spots. But when I go to start the car, The car turns on with lights, pump primes.....but no starter action. The abs, srs lights are on. But I don't remember these affecting starting. I didn't do anything else in the engine except change the cap, rotor, and plugs. Any ideas? I'm out of ideas. Thanks.

bitch is fixed!

D15Bastard

check the starter soleniod connection.

sometimes they come off if your in the area messin with wires.

ProzacOverdose

under the dash? I've checked the grouds, starter signal wire, power wires, fuses. I'm not sure why even the abs light is on. Would be cutting the 2nd air bag plugs do this? I'm going to take the dash out again this weekend if I can't figure it out.

D15Bastard

oh, if you where just under the dash, then forget what I said in the first post.

I would say main relay possible, but you hear the fuel pump priming right?

I wouldnt imagine cutting the air bag wires not allowing the car to start, but I dont know. Why did you cut it. was there not a clip like on the driverside?

ProzacOverdose

They were just sitting there and I though hmm...I don't need them. I'm going to add them back on to see what happens. But its weird that my abs light is on though. Can't figure that out. I'm going to go through all my fuses again. But I don't know what could be doing this? This freakin sucks.