b16a2 into 92dx eg hatch
well here is my problem i did my own wiring for the obd2b distributor to run of my stock harness... now with my wiring harness that i did so my distributor could run off my stock harness actually turn the car on now i do have a lounch control but is at like 4500rpms but when i turned on my b16 i took it for a drive with out connecting my knock sensor hopefully is not a problem.. but it didnt pass 3-3500rpms.. thinking that it could of been my wiring i do go back and double check my wiring so i decide to clean up my little mess with the wiring but i finished my harness and now the car doesnt turn on at all it cranks though
what could this problem be now... (hopefully i didnt fry ma distributor or coil) any help would be apreciated thanks in advance |
Re: b16a2 into 92dx eg hatch
2 Attachment(s)
now today i checked the codes and it gave me 20 and 5 on my obd1 p06 vtec converted!!!
code 20- ELD (electronic load detector) -checked the volts for this everthing is ok... code 5- MAP (manifold absolute pressure) -is gettin power i check it with my meter and the sensor is in workin order too.... i also checked my coil is also in workin order my distributor wiring from obd2b > obd1 should be working here is the diagram that i used for my wiring Attachment 19091 -on slots b13 amd b14 i have no power wats so ever when i plug my tester to the harness side Attachment 19092 -here that would be CYP+ and CYP- |
Re: b16a2 into 92dx eg hatch
damn so many b16 gurus and no one could help....
|
Re: b16a2 into 92dx eg hatch
Ok I really did not feel like reading the hole thing, but did you do it color for color?
|
Re: b16a2 into 92dx eg hatch
Originally Posted by crxvtec91
Ok I really did not feel like reading the hole thing, but did you do it color for color?
|
All times are GMT -5. The time now is 10:45 PM. |
© 2024 MH Sub I, LLC dba Internet Brands