b16a2 into 92dx eg hatch
#1
b16a2 into 92dx eg hatch
well here is my problem i did my own wiring for the obd2b distributor to run of my stock harness... now with my wiring harness that i did so my distributor could run off my stock harness actually turn the car on now i do have a lounch control but is at like 4500rpms but when i turned on my b16 i took it for a drive with out connecting my knock sensor hopefully is not a problem.. but it didnt pass 3-3500rpms.. thinking that it could of been my wiring i do go back and double check my wiring so i decide to clean up my little mess with the wiring but i finished my harness and now the car doesnt turn on at all it cranks though
what could this problem be now...
(hopefully i didnt fry ma distributor or coil)
any help would be apreciated
thanks in advance
what could this problem be now...
(hopefully i didnt fry ma distributor or coil)
any help would be apreciated
thanks in advance
#2
Re: b16a2 into 92dx eg hatch
now today i checked the codes and it gave me 20 and 5 on my obd1 p06 vtec converted!!!
code 20- ELD (electronic load detector)
-checked the volts for this everthing is ok...
code 5- MAP (manifold absolute pressure)
-is gettin power i check it with my meter and the sensor is in workin order too....
i also checked my coil is also in workin order
my distributor wiring from obd2b > obd1 should be working
here is the diagram that i used for my wiring
-on slots b13 amd b14 i have no power wats so ever when i plug my tester to the harness side
-here that would be CYP+ and CYP-
code 20- ELD (electronic load detector)
-checked the volts for this everthing is ok...
code 5- MAP (manifold absolute pressure)
-is gettin power i check it with my meter and the sensor is in workin order too....
i also checked my coil is also in workin order
my distributor wiring from obd2b > obd1 should be working
here is the diagram that i used for my wiring
-on slots b13 amd b14 i have no power wats so ever when i plug my tester to the harness side
-here that would be CYP+ and CYP-
Thread
Thread Starter
Forum
Replies
Last Post