b16a wont start please help!!!
#21
Re: b16a wont start please help!!!
Originally Posted by wafflesincars
He didn't have it at WOT.
I figured it might be the coil, they usually up and die and will still give you spark in open air.
I figured it might be the coil, they usually up and die and will still give you spark in open air.
#22
Re: b16a wont start please help!!!
do you guys read? The ignitor is in the dizzy, which he replaced. Main relays do go bad all the ------- time, but it wouldnt have fuel or spark if that was the case. It also says in the first post he checked the t-belt already... Holding the throttle wide open will only give you another 10-15psi. A cyl leakdown test will tell you where the low compression is coming from. Take the schrader valve out of the bottom of your compression tester (you'll need a special screwdriver for this) and hook it right up to an air compressor with the regulator set around 70psi. Pull the dipstick, rad cap, and intake pipe before you hook up the compressor. After you start pumping air into the cyl, listen for leaks at the dipstick, the opened throttlebody, out the back of the muffler, and then look for bubbles in the coolant in the rad.
When you identify your leak(s), heres what is wrong:
air coming from-
throttle body = bent intake valve(s)
exhaust = bent exhaust valve(s)
dipstick = beat rings
bubbles in the coolant = beat head gasket
your lucky im bored... good luck!
When you identify your leak(s), heres what is wrong:
air coming from-
throttle body = bent intake valve(s)
exhaust = bent exhaust valve(s)
dipstick = beat rings
bubbles in the coolant = beat head gasket
your lucky im bored... good luck!
Thread
Thread Starter
Forum
Replies
Last Post
W O T
General Discussion
23
12-10-2005 05:16 PM