-Auto-Manual Swap- Need tips!
Patient: 96dx
Started swap today and here's what I'm having trouble with: Lining up the Transmission dowels so I can finally bolt it to the engine! Does the transmission shaft have a master spline (that is, the splines go in a certain way?) And just want to clarify something.. Once you bolt up the clutch and remove the clutch alignment tool, the clutch disk shouldnt move right? I didnt try to mess with it when I took out the alignment tool. |
Re:-Auto-Manual Swap- Need tips!
When you use the alignment tool and then torque down the pressure plate, the disk shouldn't move.
For auto to manual shiz, check these out: http://www.torontocivics.com/article...to-manual.html http://hybrid2.honda-perf.org/tech/autoconvert.html |
Re:-Auto-Manual Swap- Need tips!
Damn, good articles. 8)
|
Re:-Auto-Manual Swap- Need tips!
Sometimes its bitch to get it lined up. It doesn't go any certain way. I just tend to twist them side to side and they pop in. Then pull them in with the bolts.
|
Re:-Auto-Manual Swap- Need tips!
it is a bitch to line up no matter what you do. sometimes it goes right in and sometimes it takes a while. my auto swap went pretty smooth besides the fact that i didn't get a manual starter at first so i couldn't start the car until i did. good luck
|
All times are GMT -5. The time now is 06:29 PM. |
© 2024 MH Sub I, LLC dba Internet Brands