8.1:1 CR?
#11
Re: 8.1:1 CR?
I'm running 9.0 Arias D16a6 pistons in my ZC which yields around a 7.8~7.9ish and I must say it sucks ***. I have to run 20~22ish psi before the car even feels alive at all. The thing was faster and funner to drive with stock pistons running 12psi.
Rollerwaves is where its at.
Rollerwaves is where its at.
#15
Re: 8.1:1 CR?
Originally Posted by Whitey
Originally Posted by Mindless
Maybe I'll invest in the expensive headgasket after all.
Invest in ARP headstuds too. Probably more important than the gasket itself
I recalculated the c/r and since I had the head milled I will be at around 8.6:1 so maybe I'll go with a stock HG after all. I am still undecided though.
#17
Re: 8.1:1 CR?
Originally Posted by AbaZ
What you plan on buying one of those expensive HKS gaskets? I'd mill the ---- out of your head and get some cam gears to pick up the slack. Because super low compression sucks imo.
#19
Re: 8.1:1 CR?
Originally Posted by AbaZ
With a set of studs and a few coats of copper spray the stock hg should be ok. It's not a MLS gasket, its just the standard composite style