75.5 mm Vitaras, what piston to wall clearance?
#14
Guest
Posts: n/a
Re: 75.5 mm Vitaras, what piston to wall clearance?
Found some pretty good info here
http://www.turbod16.com/viewtopic.ph...st=0&sk=t&sd=a
I'll probably go .002-003. I'm only shooting for 300 whp
http://www.turbod16.com/viewtopic.ph...st=0&sk=t&sd=a
I'll probably go .002-003. I'm only shooting for 300 whp
#16
Re: 75.5 mm Vitaras, what piston to wall clearance?
I'm running with .005 on all piston-cylinder clearances, absolotely no slap at all, .005 is still almolst twice the service limit according to honda's spec's. You can have the pistons knurled, which expands points of the skirt to close this gap down, I was going to have mine knurled but the machine shop didnt have a knurling tool small enough at the time so I said ---- it. she purrs like a kitten even upon a cold start up.
#17
Guest
Posts: n/a
Re: 75.5 mm Vitaras, what piston to wall clearance?
Originally Posted by SDRAWKCAB
Couldn't let me show you up could you jon?
i got my block checked and im gonna have about .005 piston to wall.
Im not worried about it.
Stock rods?
Bearing?
i got my block checked and im gonna have about .005 piston to wall.
Im not worried about it.
Stock rods?
Bearing?
#18
Guest
Posts: n/a
Re: 75.5 mm Vitaras, what piston to wall clearance?
Originally Posted by ifly87
I'm running with .005 on all piston-cylinder clearances, absolotely no slap at all, .005 is still almolst twice the service limit according to honda's spec's. You can have the pistons knurled, which expands points of the skirt to close this gap down, I was going to have mine knurled but the machine shop didnt have a knurling tool small enough at the time so I said ---- it. she purrs like a kitten even upon a cold start up.
'99 vitara 1.6
'95 z6
#20
Re: 75.5 mm Vitaras, what piston to wall clearance?
Originally Posted by jagojon3
TunerToys rods and haven't decided on bearings yet.
http://cgi.ebay.com/ebaymotors/ACL-R...spagenameZWDVW
WHAT
Block?
Head?
turbo?