HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   General Discussion (https://www.homemadeturbo.com/general-discussion-6/)
-   -   You know what really blows??? (https://www.homemadeturbo.com/general-discussion-6/you-know-what-really-blows-6711/)

Special FX 06-27-2003 02:15 PM

You know what really blows???
 
My head gasket. Over and over.

Dr.Boost 06-27-2003 04:01 PM

Re:You know what really blows???
 
Get the head surfaced along with the block and use copper spray on the gasket. I hate changing head gaskets over and over and over and over again. >:( This is the last time I swear!!!
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

45psi 06-27-2003 04:12 PM

Re:You know what really blows???
 
how much does copper spray and a head resurfacing cost?

Dr.Boost 06-27-2003 04:14 PM

Re:You know what really blows???
 
It cost me about $30 for head surfacing and I don't know about the copper spray. I haven't got that far yet. I'm sick of head gaskets and I'm going to make sure it seals good and never overheats this time.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

fiero_god 06-28-2003 08:52 AM

Re:You know what really blows???
 
the copper spray goes for like $6 her. We use it to seal up leaks in the air compressor ,its really good stuff.

Dr.Boost 06-28-2003 12:07 PM

Re:You know what really blows???
 
Is that available everywhere? I don't have to go to a special store for it? Basicaly any auto parts store? I haven't had a chance to go looking since my car is MIA. :'(
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

shortyz 06-28-2003 01:07 PM

Re:You know what really blows???
 
yeah permatex makes it.

also get the head resurfaced everytime, dont risk it. then just spend a few hours on getting it all off the engine.

Special FX 06-28-2003 02:34 PM

Re:You know what really blows???
 
I think this one is working. Used the Permatex copper spray-a-gasket and painted the gasket really good. The head had no warp. With an accurate straightedge, it showed less than 1.5 thousandths distortion. I overtorqued the head bolts to 60lbs (I know this is bad practice) but I think that helped out because the last gasket was blown over about 10 square inches total.

Dr.Boost 06-28-2003 03:11 PM

Re:You know what really blows???
 
Mine looked good on a straght edge, but the surfacing showed it was warped. It had small waves in it. We'll see Monday how well the copper spray works. :-\ God I hope it works. :(
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

imadouche 06-30-2003 09:15 PM

Re:You know what really blows???
 
i was going to say my mom


All times are GMT -5. The time now is 12:35 PM.


© 2024 MH Sub I, LLC dba Internet Brands