yay i finally got to start my hatch today
 

well like the title says, i started the hatch today...thanks to xencron for the chip. well first things first, he put a launch control setting on this chip so when i started it it had the same 3200 rpm rev limit as it did when i didnt have the mpfi swap done right, then i took it for a ride and it went away. so few, that was a little scary, well when i start it now it revs up to 3200 without me even hitting the gas, with the mpfi swap i switched the tps wires like it said, i just switched them back and forth a couple times again to see if i messed up but i didnt, what could this mean?? bad tps or...
and the best for last, i forgot to tighten the oil drain plug and it fell out, i left a nice about half mile long streak of oil down my road and into my drive, the first second i heard it knock i shut it off. and then the rest of the oil drained in my drive.

but what could be up with my high idle? any suggestion?

Re:yay i finally got to start my hatch today
 

idle air cotrol valve.

edit
it might also be the idle screw located at the top of your TB.

Re:yay i finally got to start my hatch today
 

ok ill go check it out

Re:yay i finally got to start my hatch today
 

one knock is all it takes to ruin your motor.

Re:yay i finally got to start my hatch today
 

well it did it about 4 times so well see what happenes when i put some oil back in it. thank god its only my d15 not the biult a6.

Re:yay i finally got to start my hatch today
 

you have to swap out the orange and white wires to the black/yellow and blue i beleive....check to see what color wires are running to the IACV

Re:yay i finally got to start my hatch today
 

i had a different intake manifold on about two months ago and it didnt do this, then i put on this a6 manifold and it idles high. ill check that too

Re:yay i finally got to start my hatch today
 

gaskets? vacuum leak

Re:yay i finally got to start my hatch today
 

no vac leaks, which gasket would it be. o ---- i think i might have forgoten to put a new tb gasket on when i cleaned it out. could that do it?