Who makes DA traction bar/crossmember?
#11
Re: Who makes DA traction bar/crossmember?
or you can just take the 2 bolts out of the heims to adjust... anyway looking at that design it doesn't look like it is going to leave much clearance between the block and the crossmember... you'll notice it bolts up to the same place your factory one bolts to and goes straight across. other designs bolt to and drop down from the tow hooks allowing much more clearance for that 7"er you're talkin about.
#12
Re: Who makes DA traction bar/crossmember?
Originally Posted by ososlohatch
lol it takes like 5 min you loose'n 4 bolts,then adjust the bolts on the radius rod
_ | _ |
maybe you just turn the nut on the end and it pulls the arm in and out?
#16
Re: Who makes DA traction bar/crossmember?
Adjusting a Crossmember comes into to play when your Actually making enough power to require one for anything more then added space.
When you get into preloading FWD suspension or adusting you Caster you will know the difference.
Again with this design you are only getting 180deg adjustments like crx88si said.
I'm not bashing these guys, I have seen there cars in person, and possibly even talked the shop owners? Plus they are the only ones at this moment offering a DA traction bar at sub-$350.
When you get into preloading FWD suspension or adusting you Caster you will know the difference.
Again with this design you are only getting 180deg adjustments like crx88si said.
I'm not bashing these guys, I have seen there cars in person, and possibly even talked the shop owners? Plus they are the only ones at this moment offering a DA traction bar at sub-$350.
#17
Re: Who makes DA traction bar/crossmember?
Originally Posted by ComptonsF1NEST
what do u do with the horizontal crossmember, the one that attachs from the big crossmember down to the steering area.
I dont have that in right now and i dont notice any diffence.
I dont have that in right now and i dont notice any diffence.
Originally Posted by ososlohatch
thats not good
#18
Re: Who makes DA traction bar/crossmember?
Originally Posted by ososlohatch
you didnt look to hard found this in less than 30 seconds http://cgi.ebay.com/ebaymotors/90-93...spagenameZWDVW
I was just concerned at the quality of it. I mean, you can buy a lot of ---- off ebay, and a lot of times it turns out to be ebay quality. A Crossmember is not something i would like to have fail so i was curious as to whether or not anyone else had used one or know anything about its quality or any other makers. Thanks so far for the responses folks, i'll probably end up getting one unless somebody else wants to be the HMT test dummy.
#19
Re: Who makes DA traction bar/crossmember?
Originally Posted by Castor Troy
other designs bolt to and drop down from the tow hooks allowing much more clearance for that 7"er you're talkin about.