beerbongskickass

I tried filling my stock motor mounts with that window weld ----, I think I got more on me than I did the mounts lol...

projekteg

no ----, same here :P works ok though

beerbongskickass

Mine didn't even work. That ---- just kept running out of the mounts, so I said ---- it and hosed everything off as much as I could, didn't really help though. That ---- is ------- sticky as hell.

projekteg

how long did you let it sit? i let mine cure for over 24 hrs. and they were fine

HMT-Admin

Well the key is to let them dry for a tad bit more than 24 hours, and use the calking gun correctly

beerbongskickass

I didn't let it sit at all because I couldn't get that ---- to stay in the mount. It would have just been stuck to my work bench if I let it sit for 24 hours. I think I did it wrong.

projekteg

lol, i think you used the wrong stuff. the stuff i used was too thick to just drip out on it's own.

beerbongskickass

Nah I am pretty sure it was the right stuff, it was pretty thick. I think I am just retarded.

CivicZC

I just filled mine on thursday and put them in this morning, they wern't quite dry still a little mushy onthe inside if I poked it with a needle. I needed my car so I through them in, the car vibrates alot more though but wheel hop non existent now. I give the window weld a thumbs up, just let them dry in a warm place for like two days, the cold *** shop slowed down the drying process alot. I did some in the summer and they were almost dry in 24 hours.

WhiteZC

ok...this is bullshit, i bought the motor mount inserts, and then my buddy told ne that there is no place within like 45 minutes drive that carries the window weld ----.....can i order it form somewhere online?