TwinTurbo V12 final setting :)
 

So,after doing it 3 differents way, here is the final one ... "very good flow", no commun firing cylinder in each exhaust pipe.

I did weld it like a pig ... basically,I prefered to tripped all the welding, and then erode itif required. I just tested the all side at 30bars ... no leak.

I spend a long long time to make sure I can fit those big ass T04b from Garrett. This set up fit under the hood.
I am not happy of the "look of my welding, but I had to mix different kind of standless steel, and some time , it was getting too "sparking" ... I made sure that the penetration is very deep everywhere, it is what matter the most to me ... I don t want to burn the car...

I am now cutting a lot of little piece to steel to make heat shields ... I ll wrap the exhaust into a full thermal shield, but additional protection is required for the spark plugs wires.

http://www.v12extreme.com/ipost/finalwelding3.jpg

http://www.v12extreme.com/ipost/finalwelding2.jpg

http://www.v12extreme.com/ipost/finalwelding1.jpg


May the Core be with you!

That is hand made !!!! :)

FrancoisP
http://www.v12extreme.com

O0 vrooooommmmmmm >:D

Re: TwinTurbo V12 final setting :)
 

Pretty sure that is going to make the turbo smoke like crazy. The absolute max you are suppose to tilt a tubo is something like 30 degrees.

Good luck with it though.

Later
Randy

Re: TwinTurbo V12 final setting :)
 

First off, what the ---- are you doing welding in your living room. Your moms going to kill you if you burn down the house. 2ndly, is that thing going to run or just go the stealthmode route and sit on jackstands. If it going to run, you may want to consider sitting the turbo flat for oil drain.
Just kidding about the living room, that fucken rocks.

Re: TwinTurbo V12 final setting :)
 

The tillt is really a problem? I was planning to use a separated oil pump to feed them, what do you think?

will it :6 smoke? or damage them?

FrancoisP

Re: TwinTurbo V12 final setting :)
 

Wow.

HMT v12 bmw??? ???

Where is the wastegate?

Re: TwinTurbo V12 final setting :)
 

I ll post the waste gate pic tomorrow.

FrancoisP

Re: TwinTurbo V12 final setting :)
 

yeah, that ain't gonna work out very well at all. the oil drain is only gravity fed, and needs to be as straight down as possible

Re: TwinTurbo V12 final setting :)
 

this guy is hardcore, hes got his v12 in his living room on hardwood floors with nigga ass fluxcore welds and turbos hanging off at goofy angles.

Dude, your crazy

Re: TwinTurbo V12 final setting :)
 

that thing looks like ---- and that motor is nothing but a cool ass looking paperweight. buy a pushrod v8 and stop mounting turbos half ass calked ------ style sideways upside down that will never work

Re: TwinTurbo V12 final setting :)
 

that flat out will work like ----