Stealthmode oil drain ?
Guest
Posts: n/a
Re:Stealthmode oil drain ?
drill it out a little smaller, and then slowly dremel it so that is somewhat threads in, then take a mig welder and mig weld all around it, it will melt the brass and steel together, then put jb weld aroud it, 100% good to go...
at first i just drilled, stuck it on, and slapped some jb weld on it, then it started leaking, and i though, if i spun a bearing on my crower i beams, im going to be ------ pissed off so i better take it off and do it right. sure it works sometimes, but are you willing to risk a spun bearing.
at first i just drilled, stuck it on, and slapped some jb weld on it, then it started leaking, and i though, if i spun a bearing on my crower i beams, im going to be ------ pissed off so i better take it off and do it right. sure it works sometimes, but are you willing to risk a spun bearing.
Thread Starter
0.5 BAR
Joined: Aug 2003
Posts: 176
Re:Stealthmode oil drain ?
i searched and foun that i should drill a 37/64 hole. i wasn't sure about welding it, possible braze it. also put on some of that blue rtv sealant, it worked with the old line. what do you think?
Thread
Thread Starter
Forum
Replies
Last Post
95civicLX
General Discussion
4
Dec 22, 2006 09:48 PM
mstolars
Forced Induction
3
Oct 9, 2003 12:29 AM
