Re: SBC 350 torque specs needed....Help a nog out
Thanks ------s.
|
Re: SBC 350 torque specs needed....Help a nog out
dave u should tell omar to buy a cheap Ignition box with a rev limiter O0 Im sure he would use it :8
|
Re: SBC 350 torque specs needed....Help a nog out
Originally Posted by 88dx
dave u should tell omar to buy a cheap Ignition box with a rev limiter O0 Im sure he would use it :8
|
Re: SBC 350 torque specs needed....Help a nog out
damn sorry for not chimming in sooner
I have done valve adjustments many ways and the best way i found was the the older chilton manual i have hear. TDC an adjust specific intake an exhaust vales to zero lash then 3/4 turn turn engine 180 and do the other set of intake an exhaust. Install covers an fire it up. No mess an they are quite. the turbo 350 had solid rollers an i did it when i put it in and 8 months later i ran them just before dyno day to make sure they where good.They needed slight adjustment but they where plenty close to run.Hydralics is a one time unless the cam goes south.If you need the info i can scan it an email it to you. |
Re: SBC 350 torque specs needed....Help a nog out
Originally Posted by Cadracer
damn sorry for not chimming in sooner
I have done valve adjustments many ways and the best way i found was the the older chilton manual i have hear. TDC an adjust specific intake an exhaust vales to zero lash then 3/4 turn turn engine 180 and do the other set of intake an exhaust. Install covers an fire it up. No mess an they are quite. the turbo 350 had solid rollers an i did it when i put it in and 8 months later i ran them just before dyno day to make sure they where good.They needed slight adjustment but they where plenty close to run.Hydralics is a one time unless the cam goes south.If you need the info i can scan it an email it to you. |
All times are GMT -5. The time now is 11:13 AM. |
© 2024 MH Sub I, LLC dba Internet Brands