obd0 to obd1??
im swapping a d16z6 into my 89 crx si, im using a jumper harness, obd1 distributor, and a p28 ecu, what else do i need.
|
Re:obd0 to obd1??
You have to re-pin a couple wires on the distributor's plug, instructions for this should have been included with your jumper harness. Also the P28's use a 4 wire 02 sensor, thats all you should need.
steve |
Re:obd0 to obd1??
hopefully cause everywhere i look it says stuff about the injectors and wiring and crap, i think this may be only if your not using the jumper harness right? hope so. so other than that those 3 things are all i need other than running vtec and the new o2 sensor wires.
|
Re:obd0 to obd1??
dont worry about injectors. just use your original crx injectors and run the resistor box so u dont have any trouble with wiring. just wire up the distributor and the 4 wire o2. and vtec and vtec pressure.
|
Re:obd0 to obd1??
so i dont have to worry about the injectors even if im using the p28 ecu.
|
Re:obd0 to obd1??
Originally Posted by mycrx
so i dont have to worry about the injectors even if im using the p28 ecu.
|
Re:obd0 to obd1??
hey thanks for the help.
|
Re:obd0 to obd1??
well you might want to rewire your ecu plus so it will work. Not sure if you knew that but you might want that. I am doing this now and it sucks.
|
All times are GMT -5. The time now is 05:45 AM. |
© 2024 MH Sub I, LLC dba Internet Brands