mycrx

im swapping a d16z6 into my 89 crx si, im using a jumper harness, obd1 distributor, and a p28 ecu, what else do i need.

88dx

You have to re-pin a couple wires on the distributor's plug, instructions for this should have been included with your jumper harness. Also the P28's use a 4 wire 02 sensor, thats all you should need.
steve

mycrx

hopefully cause everywhere i look it says stuff about the injectors and wiring and crap, i think this may be only if your not using the jumper harness right? hope so. so other than that those 3 things are all i need other than running vtec and the new o2 sensor wires.

BoosTedZSix

dont worry about injectors. just use your original crx injectors and run the resistor box so u dont have any trouble with wiring. just wire up the distributor and the 4 wire o2. and vtec and vtec pressure.

mycrx

so i dont have to worry about the injectors even if im using the p28 ecu.

88dx

Nope

mycrx

hey thanks for the help.

crxrx7

well you might want to rewire your ecu plus so it will work. Not sure if you knew that but you might want that. I am doing this now and it sucks.