New Turbo Install - How To Stop From Spinning *alone*??
 

Im about to swap my SSAC t04e into my crx and I realized I have a problem.

The instructions say to hold the wheel firmly when its started and to hold it for 30 seconds until oil is all over it. I thought sure I can do that

Ofcourse I never thought I would be all alone until almost 12pm tonight and frankly I just cant wait that long

How can I do this myself?

Thanks guys

Re: New Turbo Install - How To Stop From Spinning *alone*??
 

Don't cut off any fingers. Just disconnect your fuel pump relay and prime it by cranking your engine.

Re: New Turbo Install - How To Stop From Spinning *alone*??
 

just start it
not like your gonna ruin an SSAC turbo, those thing wouldn't break if you threw it off the roof. quality stuff i tell you.

Re: New Turbo Install - How To Stop From Spinning *alone*??
 

If the motor isnt turned over the oil pump is still priming? Alrighty that works then

Re: New Turbo Install - How To Stop From Spinning *alone*??
 

The motor isn't gonna turn on but its still gonna crank...

Re: New Turbo Install - How To Stop From Spinning *alone*??
 

get ur neighbors to help you ffs.. you hold it while theey start it up..

Re: New Turbo Install - How To Stop From Spinning *alone*??
 

Just wedge a piece of cheese in there

Re: New Turbo Install - How To Stop From Spinning *alone*??
 

lol stick your dick in the inlet and yell for your moms to come start the car ;D

Re: New Turbo Install - How To Stop From Spinning *alone*??
 

run a wire from the batt terminal to the starter trigour(with the key off)this will turn the engine over but wont start

Re: New Turbo Install - How To Stop From Spinning *alone*??
 

I believe pulling the ECU main fuse next to the battery will prevent the car from starting(well I know it will do that) but I believe it turns on the oil pump. Then you can just crank over the engine a couple of times and the oil should circulate. Sticking your hands in a turbo while the engine is running is just a bad idea in general.