need help with a 240v adapter/plug for my welder/heater
#11
Re: need help with a 240v adapter/plug for my welder/heater
Originally Posted by highroller54
There we go, Dr Boost FTW! Does it matter which hot wire goes to which termainal? The two hots on the plug are different sizes.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#12
Re: need help with a 240v adapter/plug for my welder/heater
Originally Posted by Dr.Boost
lol, seriously? If the two hots are different sizes....that's crazy. Are you sure? It doesn't matter which hot goes to which terminal.
#13
Re: need help with a 240v adapter/plug for my welder/heater
Originally Posted by highroller54
Ya one spade terminal is wider then the other like some 110 plugs but I dont know why since it has the top ground so its not like you could ---- that up. Thanks MrBoost
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#14
Re: need help with a 240v adapter/plug for my welder/heater
Originally Posted by Dr.Boost
4/3? WTF? That's confusing.
It's only a 2 wire plug. It's either 2 hots and a ground(220v) or a hot, neutral and a ground(120v).
Go to the hardware store or HomeDepot and get the right plug. It shouldn't take more than 5 minutes to swap them and cost around $5. :1
It's only a 2 wire plug. It's either 2 hots and a ground(220v) or a hot, neutral and a ground(120v).
Go to the hardware store or HomeDepot and get the right plug. It shouldn't take more than 5 minutes to swap them and cost around $5. :1
#15
Re: need help with a 240v adapter/plug for my welder/heater
Originally Posted by Dr.Boost
Oh, I thought you meant the wires were different sizes. :P So is your welder a 110v? What about the heater?
#17
Re: need help with a 240v adapter/plug for my welder/heater
Originally Posted by BigWheeze
Ok Romex "codes" 14/2 is a 14 awg with 2 wires in the shealth. AWG/Numbers of Wires
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#18
Re: need help with a 240v adapter/plug for my welder/heater
Originally Posted by Dr.Boost
Actually there is 3 wires, black, white and a bare. :P There is no 4/3 romex.
#19
Re: need help with a 240v adapter/plug for my welder/heater
Originally Posted by c0mpl3x
ground is assumed in wiring, it doesn't actually carry current like hots do.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#20
Re: need help with a 240v adapter/plug for my welder/heater
Originally Posted by Dr.Boost
You can buy 14-2 romex with or without a ground. :P
xx-2G uncoated ground
xx-2 black and white coated
xx-3 black white with either a red or green coated wire normaly used on a 220V outlet
Just asked my dad hes an electricians