Ok, i have my arp head studs on order, my b16 head gasket on order. and my new block ready to go in.


do i have to have my block decked and my head plained?

What do i need to do to ensure engine reseambly goes well? i dont want to pop head gaskets if i ---- up. i dont know if my helms manual is going to tell me everything.

basically im scared, because i have never had to tear apart a b series engine, and put the cams back in , and the head, and all that ----. tips suggestions? help?

see ya.

 

Did the block overheat? Get a straight edge and make sure the block is flat. I have had problems in the past, so I always get the head surfaced. I also always use copper spray on the gaskets. I love that ----.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

 

If you want to make this a one time deal and not have problems get the block decked and head milled. Worth the extra cash and you wont have any worries.

 

I've never had to get a block decked before (unless it was over-heated really bad or sleeved) I normally resurface the heads though. And copper spray is your friend