HomemadeTurbo - DIY Turbo Forum
Page 3 of 3
1
2
3
Show 40 post(s) from this thread on one page

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   General Discussion (https://www.homemadeturbo.com/general-discussion-6/)
-   -   Might as well make a "Broke this today" thread (https://www.homemadeturbo.com/general-discussion-6/might-well-make-broke-today-thread-44557/)

Xgenturbo 08-18-2005 05:18 AM
Re: Might as well make a "Broke this today" thread
 
Originally Posted by Donald125
have u taken them apart yet or you Think the PP and clutch is fine.

i`ve broke my shift fork (release fork) before, similar thing happened but mine would not disengage because the forks all cracked/bented up.
I did take everything apart, yes, fork is fine, it would be nearly impossible to break a B18A1 fork, since its about as small and short as Kain's penis, they are also all cast iron, the D series Forks are way different, they are long and made out of shitty metal and that is why they break.

Today I will see WTF is going on, hopefully I get this figured out.

88crxSi 08-18-2005 06:37 AM
Re: Might as well make a "Broke this today" thread
 
stretched cable? sounds like it to me. everything mechanically works but the clutch wont disengage because the pedal is stuck to the floor
hows the spring on the release fork look?

bumblezc 08-18-2005 10:21 AM
Re: Might as well make a "Broke this today" thread
 
Just hit up Corey's or Andy's Autowreckers man, they won't want much for one, or anything, then you'll know if it's that.

Xgenturbo 08-18-2005 02:22 PM
Re: Might as well make a "Broke this today" thread
 
Originally Posted by crx88Si
stretched cable? sounds like it to me. everything mechanically works but the clutch wont disengage because the pedal is stuck to the floor
hows the spring on the release fork look?
Its fine, when I had the tranny off and pulled on the lever the release bearing went out, and when I let go it went back in, so that is fine too.


All times are GMT -5. The time now is 03:05 AM.
Page 3 of 3
1
2
3
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands