Let's see your HMT parts pile
#15
Re: Let's see your HMT parts pile
ok so not really HMT more like HT n/a haha
pictured:
gsr cams
sirII cams (buy these from me!!!)
lsvtec oil line
GE lsvtec dowels
brand new stock bore p30s with pins
some hd press plate from a clutch kit on ebay
brand new act street disc for 92+ b series trannies
brand new exedy disc that came with ebay kit for 90-91 trannies (FOR SALE!!!)
arp head studs for a b20
cometic HG for lsvtec
full b16 gasket set
password jdm intake mani gasket
new msd wires yooooo
new itr oil pump
new gsr water pump
new gsr timing belt+tensioner
OEM oil filter!!!!
At machine shop:
b18b block
ls rods/crank arp rod bolts
b16 head
head is getting resurfaced, valve seals replaced, stock exh springs swapped out for duals from an itr, 3 angle valve job, cleaned ect NO p&P (i dun have that kinda $ right now :P)
block is getting decked, honed, cleaned
crank is getting polished/cleaned
rods are getting shot peened and resized after rod bolts are pressed in
then a full rotating assembly balance
machinist also said something about re-doing oil clearances?
In the basement/scattered around
new b16 obd1 dizzy from dist king
jkobd conversion harness obd0>obd1
p06 converted to vtec/chipped
oem honda rings
brand new hasport mounts with hydro conversion
for now im stuck with a 2001 hydro ls tranny ):
some dented up 4-1 header im borrowing from friend until i can try to afford one
stock p30 intake mani I may port out.
I just need to order an adjustable fpr, some adj cam gears and my acl std size bearings and im good to go!
I do have all the other swap stuff as well... 90-93halfshaft, 90-93 axles, rear bracket ect...
It's all going into my 90 crx si I'll take pics when i get everything back form the machine shop/when I'm assembling it all. I dun have any ultimate goals for it yet I just wanted to play my hand at an all motor honda. ---- better rip :P