ka24de ring land pwnage
 

i bought my 240 for 550 bucks a while back, 91 se fb (no lsd). the guy said he ran the engine for 36 miles w/o coolant and it had low compression, assumed it was hg or burnt rings. ... so i disassemble the engine, and the ring to wall clearance is HUMUNGOUS, i could stick a dime down the side of cylinder number 1, and the others werent looking very good either. Then upon further diassembly i pull the pistons out and they look nice, very very very shiny and new, the bearings look great, hardly any wear, and the crank looks very very good. But after closer inspection upon the pistons i find this...
http://i2.tinypic.com/osbd40.jpg


the piston to wall clearance was too large, which caused the ringlands on ALL 4 pistons to break. And yes this engine has a sticker from attarco on the side of it so i have no doubt it was bought from them, but geez, whoever did the machining on the bores did a terrible job ( pistons are .020 over) it looks like i could damn near slap some .040 over pistons in and it would fit all fine and dandy.

Re: ka24de ring land pwnage
 

Prediction: a minimum of 5 people will call you a ------ in this thread. :S

Re: ka24de ring land pwnage
 

its actually wigger.

Re: ka24de ring land pwnage
 

Re: ka24de ring land pwnage
 

That's what you get for being a dumb-ass gook wigger.

Ching chong meow, bitch.

Re: ka24de ring land pwnage
 

you guys hurt my feelings so bad, im goign to go make a im leaving thread :-[







































leaving to go ---- your mommas, all of your mommas, especially you, maybe i'll bang your sisters or daughters if theyre over 5 years old

Re: ka24de ring land pwnage
 

You are very creative, wigger-san.

http://media.putfile.com/MVI_3430

Re: ka24de ring land pwnage
 

---- son, that sux...

Re: ka24de ring land pwnage
 

how dose the piston to wall clearance being to big cause the ringlands to break? I didnt think it was possible to break ringlands NA :S

Re: ka24de ring land pwnage
 

your a ------ I mean wigger ;)