Installing Car Alarm/Keyless Entry
#1
Installing Car Alarm/Keyless Entry
Last night I was attempting to install a Ebay Special Car Alarm on the wifes Mazda Millenia S because the the lock cylinders in the doors are wearing out.
I got everything on the Alarm working except the door locks. I know how to connect it to the car and what wires to tap, but the alarm has 6 Lock wire and VERY Vaque diagrams. Any help Here is the Lock Control Wire and there description:
Orange --- NO
White --- C
Yellow --- NC
Orange/Black --- NO1
White/Black --- C1
Yellow/Black --- Nc1
and it says "Layout Graph of central control lock"
This is all the info I go. I assumed NO was Normally Open, NC was Normally CLosed, and C was Common, but when arming and disarming the system, these wire output no + or - signal from what I can tell.
Edit: noob mistake should have gone in the hybrid/tech forum
I got everything on the Alarm working except the door locks. I know how to connect it to the car and what wires to tap, but the alarm has 6 Lock wire and VERY Vaque diagrams. Any help Here is the Lock Control Wire and there description:
Orange --- NO
White --- C
Yellow --- NC
Orange/Black --- NO1
White/Black --- C1
Yellow/Black --- Nc1
and it says "Layout Graph of central control lock"
This is all the info I go. I assumed NO was Normally Open, NC was Normally CLosed, and C was Common, but when arming and disarming the system, these wire output no + or - signal from what I can tell.
Edit: noob mistake should have gone in the hybrid/tech forum
#4
Re: Installing Car Alarm/Keyless Entry
#5
Re: Installing Car Alarm/Keyless Entry
Already have. Single wire with a 1kohm resistor require on the - side of the lock, straigh - for unlock.
I have the complete car side fiqured out, just not the output from the module.
I have the complete car side fiqured out, just not the output from the module.
Thread
Thread Starter
Forum
Replies
Last Post